When ordering SACS to do the unity checks according to the Eurocode 3, the SACS manual states in section 3.6.4: “1. It is extremely important to define physical members as a span using SPAN lines.“ However, the current version of Precede has very ...

In the current input file structure in SACS there is an option to set the buckling length of the bottom flange of wide flange beams separately in the GRUP card. This means that for every physical member separate GRUP cards need to be created to se...

Under the current SACS versions, SACS uses annex F table F.1.1. of the Eurocode ENV 1993:1-1:1992 to determine the C1 factor in the elastic critical moment equation. Setting the C1 factor accurately is of paramount importance to determining the el...

Status quo: Most users have to guess the number of spacing between letters when trying to search certain sections from the output listing. An example is shown in attached Suggestion: Improve the searchability. The table of content can also act as ...

Nowadays SACS is able to show extracted fatigue results for tubular joints in precede. This is a very powerful tool compared to having only a listing. It would be helpful to have the same 3D viewer option for joint strength checks results, includi...

I would like to have the possibility to save and easily switch between 2 display color settings configurations (not model dependent), for example one with dark background for modelling and one with white background for taking screengrabs.

When plotting UCs in psvdb, SACS 2023 renders skipped members with their original color (unlike prvious versions where they where rendered in grey). This generates quite a confusion because it is not easy to determine if a member is green because ...

This feature will be usefull if for one set of joints you need to use two (or more) distinct SN curves along the jacket life time (typically a S-N curve with paint in the first 15 years and free corrosion at the end of the jacket life) This way we...

Hi, EN 1993-1-8 weld requirements requires no evaluation/check if there's full penetration weld between beam-beam joint. however, in real life full penetration welds are quite expensive and we could go with partial penetration+Fillet welds, but to...

Dear Bentley, I request to update SACS ring utility programme based on latest Roark's Formulas for Stress and Strain book. Further, the following update is desired. The unit system of present Roarks program should be updated for MKS/SI system The ...