Dear Bentley,
I currently found that PILE3D has a very limit load case to generate PILECSF for fatigue analysis. It is currently found that it is around 950-960 load cases while PSI module never face such a limit.
This will limit the nos. of wave pair to be used for transfer function generation. System error will be always found at the moment when the load cases exceeds the limitation without proper explanation in the error report.
I proposed to increase the load case limitation of PILE3D module to be similar level as PSI module. 3000 load cases can be a good and reasonable number.
See the conclusion from Bentley staff via your service support system
"The limitation has been identified specifically with the Pile3D module. Based on our investigation, this is currently identified as a software limitation. The program can reliably accommodate up to 954 load cases in this workflow. In some instances, a slightly higher number, such as 960, may appear to work; however, this behavior is not reliable because it depends on memory being accessed beyond the allocated array."
Thanks